CV Personal Website


FA
Ehsan Eftekhari

Ehsan Eftekhari

Assistant Professor

e.eftekhari@birjandut.ac.ir

دانشکده/پردیس: Mechanical and Materials Engineering

گروه/دانشکده Mechanical Engineering

Degree: Professional Doctoral

Birth Year: 1981

CV Personal Website
FA
Ehsan Eftekhari

Assistant Professor Ehsan Eftekhari

e.eftekhari@birjandut.ac.ir
دانشکده/پردیس: Mechanical and Materials Engineering - گروه/دانشکده Mechanical Engineering Degree: Professional Doctoral | Birth Year: 1981 |

My affiliation

Faculty member

Mechanical Engineering Department

Faculty of Mechanical and  Materials Engineering

Birjand University of technology

Birjand, Iran.

Show More

Design of tube Hydroforming system with the Die Ultrasonic Vibration

AuthorsS.E. Eftekhari Shahri, S.Y. Ahmadi Brooghani, and K. Khalili
Journalhttps://jsfm.shahroodut.ac.ir/article_412.html
Page number135-148
Volume number۵
Paper TypeFull Paper
Published At۲۰۱۵
Journal GradeScientific - research
Journal TypeTypographic
Journal CountryIran, Islamic Republic Of

Abstract

In tube hydroforming process, due to friction condition, uniform wall thickness, as well as sharp corners may not be achieved. Use of ultrasonic vibration can improve the contact conditions at the tube-die interface. The current work studies the effect of applying ultrasonic vibration on wall thickness and corner filling of hydroformed tubes. By comparing the FEM models of tubes in two cases of with vibration and without vibration, it is possible to investigate the effects of vibration on wall thickness and corner filling. In addition, the finite element analysis, as the modal and harmonic analysis, are used to design a set of ultrasonic tube hydroforming. Annealed copper tubes are used for the experimental tests. The simple mechanism introduced in this paper is used to form the tube, by which the final piece is produced with lower costs and without any need to hydroforming machine. The results indicate superimposing ultrasonic vibrations to the process will increase corner filling ratio of the tube significantly, and more uniform tube wall thickness will be achieved.

Paper URL